在磁场中活性炭吸附有机物的研究

将磁化技术引入吸附过程中，考察了磁场处理对活性炭吸附苯、硝基苯、苯甲酸、氯苯和苯酚的影响．结果表明，预磁处理能使非极性物质苯和极性较小的氯苯、苯酚在活性炭上的吸附容量减小，而使极性较大的苯甲酸和有NO2基团的硝基苯的吸附容量增大．增大磁场强度能加强苯和苯甲酸的磁处理效果。     

A Simulation of Temporal and Spatial Variations in Carbon at Landscape Level: A Case Study for Lake Abitibi Model Forest in Ontario,Canada

Using a case study of the Lake Abitibi Model Forest (LAMF), this study aims to assess the temporal and spatial variability in carbon storage during 1990–2000, and to present a comprehensive estimation of the carbon budget for LAMF's ecosystems. As well, it provided the information needed by local forest managers to develop ecological and carbon-based indicators and monitor the sustainability of forest ecosystems. Temporal and spatial carbon dynamics were simulated at the landscape level using ecosystem model TRIPLEX1.0 and Geographical Information System (GIS). The simulated net primary productivity (NPP) and carbon storage in forest biomass and soil were compared with field data and results from other studies for Canada's boreal forests. The results show that simulated NPP ranged from 3.26 to 3.34 tC ha⁻¹ yr⁻¹ in the 1990s and was consistent with the range measured during the Boreal Ecosystem-Atmosphere Studies (BOREAS) in central Canada. Modeled NPP was also compared with the estimation from remote sensing data. The density of total above-and belowground biomass was 125.3, 111.8, and 106.5 tC ha⁻¹ for black spruce, trembling aspen, and jack pine in the LAMF ecosystem, respectively. The total carbon density of forested land was estimated at 154.4 tC ha⁻¹ with the proportion of 4:6 for total biomass and soil. The analysis of net carbon balance of ecosystem suggested that the LAMF forest ecosystem was acting as a carbon sink with an allowable harvest in the 1990s.     

有机气溶胶的来源与形成研究现状

介绍了有机气溶胶来源与形成的研究现状,从有机气溶胶的化学组成特征、一次有机气溶胶的来源和二次有机气溶胶的形成机制论述其研究进展.一次有机气溶胶主要来源于烹调油烟、机动车排放、生物质燃烧、工业或民用燃油锅炉释放出的有机物,还有道路扬尘、沥青、刹车尘、轮胎屑、室外香烟烟雾、以及高等植物蜡、细菌活动和草本植物等.大气中的半挥发性有机物可通过物理和化学吸附形成二次有机气溶胶,一些挥发性有机物可通过气相化学反应转化为低挥发性的物质并形成二次有机气溶胶,其主要前体物是芳香族化合物,如苯、甲苯、二甲苯,以及烯烃、烷烃、环烷烃、萜烯和生物排放的非饱和氧化物.     

气相色谱法测定二硫化碳和甲硫醚

利用气相色谱(配火焰光度检测器,采用3mxφ2mm玻璃填充柱分离)对CS2和甲硫醚(DMS)两种含硫化合物进行了分离检测。该方法具有较高的灵敏度和良好的线性关系。结果表明:该分析对含硫气体的最小检测浓度在mg/m3级,在柱温为70℃,检测器温度为180℃,气化室温度为150℃,氮气流速为50mL/min时,CS2的回收率为98.66%,变异系数为2.12%;甲硫醚的回收率为98.66%,变异系数为1.56%。     

铁炭内电解法处理染料废水的试验

文章采用铁屑一活性炭内电解法作为光合细菌生化处理染料废水的预处理方法，考查了3个主要影响因素（铁炭比、停留时间、初始pH值）。结果表明，最佳的处理条件为：铁炭比为7：3，pH值为5，停留时间为60min。在上述最佳处理条件下，对初始COD为6790mg／L的染料废水处理效率可以达到66．1％，并且废水经预处理后可生化性得到大大提高，有利于后续生化处理的进行。     

Developing Canada's National Forest Carbon Monitoring, Accounting and Reporting System to Meet the Reporting Requirements of the Kyoto Protocol

The rate of carbon accumulation in the atmosphere can be reduced by decreasing emissions from the burning of fossil fuels and by increasing the net uptake (or reducing the net loss) of carbon in terrestrial (and aquatic) ecosystems. The Kyoto Protocol addresses both the release and uptake of carbon. Canada is developing a National Forest Carbon Monitoring, Accounting and Reporting System in support of its international obligations to report greenhouse gas sources and sinks. This system employs forest-inventory data, growth and yield information, and statistics on natural disturbances, management actions and land-use change to estimate forest carbon stocks, changes in carbon stocks, and emissions of non-CO₂ greenhouse gases. A key component of the system is the Carbon Budget Model of the Canadian Forest Sector (CBM-CFS). The model is undergoing extensive revisions to enable analyses at four spatial scales (national, provincial, forest management unit and stand) and in annual time steps. The model and the supporting databases can be used to assess carbon-stock changes between 1990 and the present, and to predict future carbon-stock changes based on scenarios of future disturbance rates and management actions.     

Carbon Dioxide Balance of Wood Substitution: Comparing Concrete- and Wood-Framed Buildings

In this study a method is suggested to compare the net carbon dioxide (CO₂) emission from the construction of concrete- and wood-framed buildings. The method is then applied to two buildings in Sweden and Finland constructed with wood frames, compared with functionally equivalent buildings constructed with concrete frames. Carbon accounting includes: emissions due to fossil fuel use in the production of building materials; the replacement of fossil fuels by biomass residues from logging, wood processing, construction and demolition; carbon stock changes in forests and buildings; and cement process reactions. The results show that wood-framed construction requires less energy, and emits less CO₂ to the atmosphere, than concrete-framed construction. The lifecycle emission difference between the wood- and concrete-framed buildings ranges from 30 to 130 kg C per m² of floor area. Hence, a net reduction of CO₂ emission can be obtained by increasing the proportion of wood-based building materials, relative to concrete materials. The benefits would be greatest if the biomass residues resulting from the production of the wood building materials were fully used in energy supply systems. The carbon mitigation efficiency, expressed in terms of biomass used per unit of reduced carbon emission, is considerably better if the wood is used to replace concrete building material than if the wood is used directly as biofuel.     

铜铁矿井下采掘工程的环境影响及生态保护

对铜铁矿井下采掘工程产生的环境影响进行了分析，外排井下涌水下的铜可对鱼类养殖业水体的地表水质带来不利影响，采用帷幕注浆堵水工艺可防止大面积地表塌陷的发生，对难以避免的局部，小规模塌陷提出了生态安全的预警措施。     

铸态珠光体基体球墨铸铁 S195曲轴的研制

针对生产实际要求,研究了微量元素加入量、开箱时间等对铸态球墨铸铁珠光体量及性能的影响,试验了铸态球墨铸铁曲轴的各种常规性能.     

活性炭吸附与生物活性炭脱臭效果的比较研究

针对污水收集与处理系统中恶臭气体的组成与特性,比较分析不同情况下活性炭吸附与生物活性炭的脱臭效果。当干活性碳总处理气量达到1.3m~3/g时,出现穿透。将吸附饱和的活性炭填料塔转为生物滴滤反应器后,仍能较快的实现挂膜生长,达到满意的处理效果。直接运行的生物活性炭滴滤器对H_2S的处理效率在95％以上,并具有较强的恢复能力。H_2S平均出口浓度为0.052mg/m~3。循环液pH值与盐度在一定范围内对系统影响不大。